Introduction Rolling Mills

AUTOMATION & ELECTRICAL EQUIPMENT FOR Melt Shops:

In order to feed the rolling mill with a billet at a deformable temperature, billets are reheated inside a reheating furnace. The rolling process of long products of steel consists of feeding the billets through two rolls which are rotating at the same speed but in opposite directions, the rolled stock is reduced by pressure, until the desired shape of final product. Afterwards, the hot bar is cooled at the cooling bed, cut to commercial length and straightened so that it can achieve the final dimensions and tolerances and finally packed at the evacuation area to be stored or transported.

Efficiency & reliability

Bascotecnia Steel supplies all kind of rolling mills

  • Bar mills and merchant mills.
  • Sections mills.
  • Wire rod mills.

Rolling can be either continuous rolling, which consist on rolling the bar at the rolling mill in one single direction throughout the roughing, intermediate and finishing stands, or discontinuous rolling, consisting on alternated rolling stands in the roughing mill, normally composed of two-high and three-high stands. Subsequent phases are continuous.

Bascotecnia Steel provides rolling mill solutions

  • Designs flexible rolling mills to handle with different ranges of products.
  • Offers efficient plants, focusing on the plant yield by minimizing the short bars, the number of cobbles and crops and the minimization of downtime.
  • Studies the most suitable roll pass design as per product mix and customer demands.
  • Manufactures low operational cost equipment, work with long life consumables and standardised spares parts
  • Ensures the high quality of rolling products.
  • Operates with the optimal men power requirements.
Rolled in a rolling mill